Industrial Air Cooler Use in Injection Molding Workshop

Injection molding workshop environmental problems formation factors and characteristics analysis:

Injection molding plant workshop environmental problems have been these enterprises attach great importance to a problem, especially at present energy saving and emission reduction and environmental protection requirements are very high today, when the injection molding workshop to open a dozen or even dozens of injection molding machine high-speed moving line, the workshop will soon have high temperature and stuffy, pungent odor of the environmental problems appear, that appear such environmental disturbances on this type of production and processing enterprises is also very great, the impact of the The biggest two one is to affect the physical health of employees, the second is to reduce the efficiency of workers. According to the relevant departments in 2020 on the Guangdong N more than one injection molding factory random sampling research found that more than 80% of the injection molding enterprise workshop environmental problems are very prominent, high temperature and stuffy heat, pungent odor air quality is poor is their common problem, that these enterprises must face the problem of rectification and improvement.

Injection molding workshop ventilation cooling recommended the following effective solutions:

1.environmental protection air conditioning cooling program: separate use of air conditioning to cool the main engine has two installation options, blowing program is mainly for small areas of the workshop to do the overall ventilation and cooling environment to improve the use of that if the area of the environment is relatively large generally need to be used to localized fixed-point post cooling, will be in the workshop, so the need to cool down the small area of the workshop alone to open a small air outlet for the air cooling, energy-saving and money-saving effect is good to get a lot of enterprises very much! Recognized.

2.fan combination cooling program: this match is in fact for that kind of ventilation is especially not smooth environment, this environment has a common problem that is stuffy and hot, air quality is not high, must be replaced with high indoor ventilation, but also to send cold air to reduce the ambient temperature, then this program is just right, through the environmental protection air-conditioning indoor into the source of a steady stream of fresh, cool, clean cold air, and then the negative pressure fan The role of the workshop is to keep the original hot air pumped away, so that the workshop to form a high-speed replacement of the scene, so that the indoor air quality is naturally good, and the temperature is also reduced, the investment cost is low and good results.

3. fan combination cooling program: This program is actually environmental protection air-conditioning + industrial fan is a combination of cooling, fan combination is a shortened version of its combination of this combination of ventilation and cooling effect is also quite good, but it is the core of the cooling The effect is quite good, but its core advantage is not based on the original environmental protection air conditioning cooling program to increase the cooling effect, and reduce the environmental protection air conditioning air supply piping engineering materials to achieve the purpose of reducing investment costs, which is more in line with some of the large steel structure of the tin roof, and brick structure of the plant can also do a good job of ventilation and cooling of the plant at a low-cost budget.

Injection molding workshop ventilation and cooling environment to improve the proposed installation of new energy-saving and power-saving evaporative chiller, which uses water evaporation to take away the heat of the air this physical principle to achieve the purpose of cooling, boot running a minute of rapid cooling 5-12 ℃, widely used in the tin tile workshop to do ventilation and cooling environment to improve the original 38 ℃ of the workshop environment fixed-point post to cool down to 26-28 ℃, and always experience the freshness and coolness of the natural cold air. The natural cold wind.

Injection molding workshop ventilation cooling solutions recommend the use of evaporative chillers for the reasons:

1.A one-time solution to the workshop ventilation, cooling, ventilation, oxygen, in addition to odor and other environmental issues, whether it is the overall cooling or post cooling effect is very significant.

2.Than the traditional air conditioning to save 75% of the installation cost, the use of power consumption reduced by 80%, than the fan also saves electricity, the enterprise can afford to use.

3.Good product quality, long service life, one-time installation can be used 10-15 years.